Dribs and Drabs
Nov. 15th, 2011 07:51 pmGot home and the house smelled wonderfully like Christmas pudding. Not being happy with our stockpot and its steamer insert, Wonderful Husband co-opted both of my canning pots (water bath and pressure) and used them to steam the two puddings instead. So now they get covered up and tucked away (probably in the back bedroom since it's (1) little-used, (2) cat-proof, and (3) the coldest room in the house) for the next month and ten days. Then, while I was washing up the dishes from his first round of endeavors, he mixed up the Christmas cake, which will be going in the oven momentarily.
Also, odd note from my last gym session: being a bit worn out on Elv1s and Daft Punk's Discovery album, I cast about my fake!Pod to see what else we had ripped from CD. *NSync's Celebrity album is pure suckage for the gym, but NKOTB's Hangin' Tough is actually not too bad.
And, finally, I found one of my plastic tubs which will fit the Singer sewing machine in it in most configurations (sitting right-side up, sadly, being the one it won't do; it's too long for the tub), and poured a gallon and a half of EvapoRust in with it. The machine has been sitting with its neck down for a couple of days, since that's where most of the internal corrosion is; I'm tilting it back and forth a couple ways so all the parts get a good soak. Then I'll do the head, let it all drain, and go back to seeing if I can get it to unfreeze.
Also, odd note from my last gym session: being a bit worn out on Elv1s and Daft Punk's Discovery album, I cast about my fake!Pod to see what else we had ripped from CD. *NSync's Celebrity album is pure suckage for the gym, but NKOTB's Hangin' Tough is actually not too bad.
And, finally, I found one of my plastic tubs which will fit the Singer sewing machine in it in most configurations (sitting right-side up, sadly, being the one it won't do; it's too long for the tub), and poured a gallon and a half of EvapoRust in with it. The machine has been sitting with its neck down for a couple of days, since that's where most of the internal corrosion is; I'm tilting it back and forth a couple ways so all the parts get a good soak. Then I'll do the head, let it all drain, and go back to seeing if I can get it to unfreeze.
no subject
Date: 2011-11-16 04:12 am (UTC)